![]() I had to use their CS once before and Todd was excellent to get the issue fixed.Nope. ![]() Worth sending them a PM here and/or an email. ![]() Likely better than suppressor subforum if you’re trying to get in touch with them to get this fixed. Perhaps post this in their industry sub forum. You can see there's usually room on the safety side of the gun for a few degrees rotation and then just use a dremel and zip a few thou off the gas block screw on the side. Just try to lighten up on accusations and dragging a company through the mud before you exhaust a few more resources. Someone will be along and they will help. Have some coffee, and send them an email as well as filling out the contact form. The DD rail was more money and didn't work with the combo I ran, and I decided adjusting gas was more important than being picky about the rail. The combo works and all are solid products. I now have 4 slr gas blocks, and just run geissele rails. That was solid and above and beyond as all I was looking for was to buy a new screw. The next week I received a brand new gas block (his block wasn't the defect, I was). But I will tell you that via email, when I tried to get the screw off after I shaved it down, he told me to print the email and send him the block and email. You can also tilt it slightly off center to make room. I shaved it down at the side screw after having the same issue. I had a Daniel defense rail and an slr gas block.
0 Comments
Leave a Reply. |